Trapezoidal Sheet Mounting Kit by K2 Systems for 3 Modules

Introduction

The K2 Trapezoidal Sheet Mounting Set for 3 Modules is specifically designed for the installation of photovoltaic modules on trapezoidal sheet roofs. It combines all necessary components in one set, allowing you to install quickly, precisely, and safely. By using high-quality materials such as aluminum, fiberglass-reinforced plastic, and stainless steel, the system is durable, corrosion-resistant, and prepared for changing weather conditions.

Thanks to the well-thought-out "floating" design, controlled thermal expansion is enabled, minimizing stress on the roof sheet. This principle is a proven component of the K2 BasicRail system.

The installation is completed in just a few steps – particularly efficient on trapezoidal sheets. With its modular design, extensions or adjustments can also be easily realized.

This set is ideally suited for private homes, carports, or smaller commercial installations where modular and flexible mounting is desired.

All components are coordinated and factory-tested. The construction meets common standards and building approvals (e.g., abZ / general building authority approval) for use on trapezoidal sheet systems.

With the K2 Trapezoidal Sheet Mounting Set for 3 Modules, you receive a well-thought-out complete system that saves installation time, provides safety, and ensures long-lasting functionality.

Technical Specifications

• Materials: Aluminum (rails), PA (plastic clips), stainless steel / galvanized steel (clamps & screws)
• Length of mounting rails: 4.80 m
• Compatible module frame height: 25–40 mm (middle) / 30–42 mm (ends)
• System design: floating with thermal expansion compensation
• Wind and snow load reserves according to K2 system approval
• General building authority approval for trapezoidal sheet applications with BasicClip and screws

Scope of Delivery

• 12 × K2 BasicClip (Art. 1001164)
• 4 × K2 Clamp MC 25-40 (Art. 2004148)
• 4 × K2 OneEnd Black Set 30-42 (Art. 2002589)
• 4 × K2 BasicRail 22, length 2.4 m (Art. 2003460)
• 2 × K2 BasicLock 22 Set (Art. 1003558)
• 24 × Thread-forming screw 6×38 (Art. 2282)
• 4 × K2 Middle Clamp (Art. 2004148)

Note

Please check if the local conditions of your construction project differ from these assumptions and require changes. This package does not replace planning by K2 Base. Solarscouts assumes no liability for the planning and statics of installations built with this package.